main

.pio/libdeps/esp32-s3-devkitc-1/RTClib/examples/ds1307SqwPin/ds1307SqwPin.ino

@@ -0,0 +1,63 @@
+// SQW/OUT pin mode using a DS1307 RTC connected via I2C.
+//
+// According to the data sheet (http://datasheets.maxim-ic.com/en/ds/DS1307.pdf), the
+// DS1307's SQW/OUT pin can be set to low, high, 1Hz, 4.096kHz, 8.192kHz, or 32.768kHz.
+//
+// This sketch reads the state of the pin, then iterates through the possible values at
+// 5 second intervals.
+//
+
+// NOTE:
+// You must connect a pull up resistor (~10kohm) from the SQW pin up to VCC.  Without
+// this pull up the wave output will not work!
+
+#include "RTClib.h"
+
+RTC_DS1307 rtc;
+
+int mode_index = 0;
+
+Ds1307SqwPinMode modes[] = { DS1307_OFF, DS1307_ON, DS1307_SquareWave1HZ, DS1307_SquareWave4kHz, DS1307_SquareWave8kHz, DS1307_SquareWave32kHz};
+
+
+void print_mode() {
+  Ds1307SqwPinMode mode = rtc.readSqwPinMode();
+
+  Serial.print("Sqw Pin Mode: ");
+  switch(mode) {
+  case DS1307_OFF:              Serial.println("OFF");       break;
+  case DS1307_ON:               Serial.println("ON");        break;
+  case DS1307_SquareWave1HZ:    Serial.println("1Hz");       break;
+  case DS1307_SquareWave4kHz:   Serial.println("4.096kHz");  break;
+  case DS1307_SquareWave8kHz:   Serial.println("8.192kHz");  break;
+  case DS1307_SquareWave32kHz:  Serial.println("32.768kHz"); break;
+  default:                      Serial.println("UNKNOWN");   break;
+  }
+}
+
+void setup () {
+  Serial.begin(57600);
+
+#ifndef ESP8266
+  while (!Serial); // wait for serial port to connect. Needed for native USB
+#endif
+
+  if (! rtc.begin()) {
+    Serial.println("Couldn't find RTC");
+    Serial.flush();
+    while (1) delay(10);
+  }
+
+  print_mode();
+}
+
+void loop () {
+  rtc.writeSqwPinMode(modes[mode_index++]);
+  print_mode();
+
+  if (mode_index > 5) {
+    mode_index = 0;
+  }
+
+  delay(5000);
+}