v2.9

lib/SparkFun u-blox Arduino Library/examples/Example1_BasicNMEARead/Example1_BasicNMEARead.ino

@@ -0,0 +1,51 @@
+/*
+  Read NMEA sentences over I2C using Ublox module SAM-M8Q, NEO-M8P, ZED-F9P, etc
+  By: Nathan Seidle
+  SparkFun Electronics
+  Date: August 22nd, 2018
+  License: MIT. See license file for more information but you can
+  basically do whatever you want with this code.
+
+  This example reads the NMEA setences from the Ublox module over I2c and outputs
+  them to the serial port
+  
+  Feel like supporting open source hardware?
+  Buy a board from SparkFun!
+  ZED-F9P RTK2: https://www.sparkfun.com/products/15136
+  NEO-M8P RTK: https://www.sparkfun.com/products/15005
+  SAM-M8Q: https://www.sparkfun.com/products/15106
+
+  Hardware Connections:
+  Plug a Qwiic cable into the GPS and a BlackBoard
+  If you don't have a platform with a Qwiic connection use the SparkFun Qwiic Breadboard Jumper (https://www.sparkfun.com/products/14425)
+  Open the serial monitor at 115200 baud to see the output
+*/
+
+#include <Wire.h> //Needed for I2C to GPS
+
+#include "SparkFun_Ublox_Arduino_Library.h" //http://librarymanager/All#SparkFun_u-blox_GNSS
+SFE_UBLOX_GPS myGPS;
+
+void setup()
+{
+  Serial.begin(115200);
+  Serial.println("SparkFun Ublox Example");
+
+  Wire.begin();
+
+  if (myGPS.begin() == false)
+  {
+    Serial.println(F("Ublox GPS not detected at default I2C address. Please check wiring. Freezing."));
+    while (1);
+  }
+
+  //This will pipe all NMEA sentences to the serial port so we can see them
+  myGPS.setNMEAOutputPort(Serial);
+}
+
+void loop()
+{
+  myGPS.checkUblox(); //See if new data is available. Process bytes as they come in.
+
+  delay(250); //Don't pound too hard on the I2C bus
+}